Jason Door Topper - Laser Version

Apparently the lake wasn't creepy enough, so now he's hanging around your doorway. 😂

This masked-slasher laser door topper features an imposing masked figure peeking over the door frame with a knife raised in one hand. The opposite arm extends down the side of the trim, helping create the illusion that the character is actually reaching around the corner.

Bold dark areas and detailed engraved linework make this one immediately recognizable as classic slasher-style Halloween décor.

The included SVG contains the detailed raster artwork for engraving along with a red vector outline for cutting.

Tested Material & Laser Settings

These are the settings used to produce the finished example shown in the photos.

Laser: 40W xTool Material: 1/4" (6 mm) Pine Ponderosa Plywood

Engraving: Power: 40% Speed: 100 mm/s Passes: 1 Bitmap Mode: Jarvis Resolution: 100 lines/cm Engraving Mode: Bi-directional

Cutting: Power: 100% Speed: 4 mm/s Passes: 1 Kerf Offset: Off Lower Focus: Off Tab Generation: Off

The red vector outline is the cut line and the detailed raster artwork is intended for engraving .

These settings produced the pictured example. Different plywood, focus, lens condition, and individual machines may require adjustment, so test your material first.