Tesla 3/Y Cup Holder for Stanley Quencher 64oz

Boost Me 💧 Built for the 64 oz Stanley Quencher

Are you so thirsty that a normal cup just isn’t cutting it? 😂

This adapter was designed for the absolute unit that is the Stanley Quencher H2.0 64 oz, so you can finally bring it along in your Tesla without having it flop around the center console.

It securely supports the lower body of the tumbler while leaving a large opening for the handle. The center is open to reduce unnecessary material while the tapered sides keep the cup supported and stable.

🚗 VEHICLE FITMENT

Tesla Model Y 2021–2024 Pre-Juniper

Tesla Model 3 2021–2023 Pre-Highland

✅ Physically tested on a 2024 Model Y ✅ Physically tested on a 2022 Model 3

The adapter uses the factory cup holder and is designed to remain centered rather than offsetting the weight of the large tumbler.

🥤 CUP COMPATIBILITY

Designed specifically for:

Stanley Quencher H2.0 FlowState 64 oz

The large side opening provides clearance for the Stanley handle while keeping the tumbler supported around the lower body.

🔥 MATERIAL RECOMMENDATION

PETG is strongly recommended.

This part lives inside a vehicle, and car interiors can get extremely hot. PETG, ASA, or ABS are much better choices for this application.

PLA is not recommended unless you want to discover modern art where your cup holder used to be. 😂

🖨️ RECOMMENDED PRINT SETTINGS

0.4 mm nozzle

0.20 mm layer height

4 walls

15% gyroid infill

No supports

Print upright as provided

The included 3MF print profile contains the settings used for the tested print.

✅ DESIGNED AND TESTED FOR REAL USE

One-piece design

No supports required

Large Stanley handle clearance

Material-saving open center

Strong tapered support

Tested in an actual Tesla Model Y and Model 3

If you’re hauling around 64 oz of hydration like you’re preparing to cross the Sahara, this should keep it where it belongs. 😎