The Golf Tee Solitaire Game

Golf Tee Solitaire & Halma Board Game ⛳️

Bring a classic strategy puzzle to life with a golf twist! This board features a 150 mm scaled golf ball texture with dimples and holds standard golf tees as game pieces. Whether you have real golf tees lying around or want a 100% 3D-printed setup, this model has you covered!

🎨 Model Features & Printing Info

- Real Golf Tee Compatible : Already play golf? Swap in standard real-world golf tees for an authentic feel. - 3D-Print Optimized Tees: The included printable "Pseudo-Tees" are designed specifically for smooth, support-free printing. They fit the board sockets perfectly (Note: They are purely for gameplay and won't balance an actual golf ball!) . - Support-Free Print: Designed from the ground up for clean bridging and effortless slicing on standard print profiles. 📜 Game Rules & How to Play

You can play this board in two distinct modes:

1. Single-Player Mode (Classic Solitaire)

- Setup: Place a tee in every hole except the center hole, leaving it empty. - How to Move: Select any tee and jump over an adjacent tee into an open empty spot directly behind it. Moves can be horizontal or vertical (no diagonal jumps). - Removing Pieces: Every tee you jump over is removed from the board. - Goal: Keep jumping and removing tees until no valid jumps remain. The ultimate goal is to end the game with only one single tee remaining on the board , ideally right in the center hole! If you are getting desperate trying this, you can look up a solution in the video below. 2. Two-Player Mode (Halma Style)

- Setup: Fill the entire board with tees, leaving only the center hole empty. - How to Play: Players take turns making one move at a time. - Multi-Jumps: On your turn, you can jump over a tee into an empty spot and collect that tee. If your tee lands in a position where another jump is immediately available, you may continue jumping in the same turn—collecting every tee you jump over. - Game End & Winning: The game ends when neither player can make a valid jump. Both players count their captured tees. The player with the most collected tees wins! 🖨️ Recommended Print Settings

- Layer Height: 0.2 mm (0.16 mm for smoother dimple curves) - Infill: 15% Grid or Gyroid - Supports: None needed! - Material: PLA or PETG If you enjoy this model, please leave a rating, upload a make, and share your high scores! Happy printing!

Single-Player Solution