A1 mini Plate Holder Ikea Skadis/Uppspel

A1mini Plate Holder Skadis 0.2mm layer, 3 walls, 15% infill Working on this complicated model takes a lot of time and if you like my work and want to support me - please print my “Designer” print-profiles! Thank you in advance!🙏

Skadis/Uppspel (IKEA) holder for 4x A1mini build plates!

Skadis/Uppspel-Build plate holder for A1mini. This can hold 4 build plates very comfortably! 👌

This holder was specially designed to be very narrow while still holding the plates very well, and it can be attached to the popular Skads/Uppspel pegboard from IKEA to save space on the maker table. 😉

This holder is easy to print on the A1mini - just use my well tuned print profiles.😍 I used two “Mice-Ears” for better bed adhesion and two tree supports for upper hooks there - just remove them off easily after printing (with pliers/cutter knife)👍

If you don't want to use print profiles - STLs with and without “Mice Ears” are attached here too. Just print them with default PETG/PLA settings.

Print Instructions:

- just use your favorite default PETG/ PLA profile, BUT - set your printer better to the “silent” mode for better quality of the walls! — ! —

Thanks for downloading and rating in advance and please don't forget to like this model! :-)

Take a look at my other very helpful designs for X1/P1P/P1S/A1/A1mini:

🔗 Eds_3D_Shop designs on MakerWorld 🔗

If you like my work and want to support me - please follow me https://linktr.ee/eds_3d_shop and if you want - you can buy me a coffee! https://linktr.ee/eds_3d_shop

Thank you for your support and.. happy printing!

Ed ;-)