Airless Ball that bounces V1

Yes, this ball really bounces. Printed with regular PLA.

Try it on your own and have fun!

(scale ball down in slicer to get same size as in the photos)

Disclaimer / Terms of Use

- Use at Your Own Risk: This design is provided "as is" for hobbyist purposes only. I am not a professional engineer and shall not be held liable for any damages (property damage or personal injury) resulting from the use or failure of this model. - Material Selection & Preparation: You are responsible for choosing the correct filament (e.g., heat-resistant or flame-retardant) for your specific application. Ensure that the filament is completely dry before printing. For maximum structural integrity and mechanical strength, it is necessary to use a freshly unpacked, new spool of filament. - Electronics Warning: When used in combination with electronics, ensure proper insulation and adequate ventilation. Do not use this model with electrical voltage unless you are a certified professional. - No Warranty: I cannot guarantee the mechanical strength or dimensional accuracy of the print, as 3D printing results vary significantly depending on the printer, calibration, and individual settings.