Blood Moon

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can adjust the X and Y but the Z must remain the same. You may print at higher layer heights below the Min Depth of 0.48mm Actual Depth is 2.2mm

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Grey Transmission Distance: 1 PLA BambuLab Basic White Transmission Distance: 5 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Yellow Transmission Distance: 6 This print uses 7 unique filaments. Substitute as needed.

Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Blue Gray At layer #11 (0.96mm) swap to Grey At layer #15 (1.28mm) swap to White At layer #19 (1.6mm) swap to Orange At layer #23 (1.92mm) swap to Red At layer #25 (2.08mm) swap to Yellow for the rest.

Boost Me Got a Boost to spare? Every little bit helps the motivation. Thank you!

Membership Want to go commercial or maybe just show some love? Consider signing up to show support!