Raspberry Pi 5 Snap Fit Vented Case

0.2mm layer, 2 walls, 15% infill 0.2mm height, full color with arachne so that the fine details are kept.

A little enlarged for easy assembly The original version is too tight, make it a little larger for easy assembly while still fit perfectly.

0.2mm layer, 2 walls, 15% infill RPi themed case!

0.2mm layer, 2 walls, 15% infill PLA

0.2mm layer, 2 walls, 15% infill E-ABS

Optimized Profile Least amount of Color Swaps. For the Fastest Print, while retaining ALL detail

0.2mm Layers, Archane Walls

Fixed version with mounting holes! Unlike every other version, this model is ready to print perfectly because it has no missing faces!

Furthemore this model has 4 mounting holes in total, one on each side.

I recommend you lower the speed of the first layer to around 30 mm/s in order to print the fine details on the first layer. Also, for better bed adhesion since there are so many air vents on the case. Furthemore this model has 4 mounting holes on all 4 sides.

Fixed version with no missing faces! Unlike every other version, this model is ready to print perfectly because it has no missing faces!

I recommend you lower the speed of the first layer to around 30 mm/s in order to print the fine details on the first layer. Also, for better bed adhesion since there are so many air vents on the case.