Dragon Cloud

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can change X and Y but Z must remain the same. You may print at higher layer heights below the Min Depth of 0.48mm Actual Depth is 2.2mm

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Silver Transmission Distance: 0.5 PLA PolyLite White Transmission Distance: 5 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 5 This print uses 6 unique filaments. Substitute as needed.

Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Blue Gray At layer #8 (0.72mm) swap to Silver At layer #11 (0.96mm) swap to White At layer #15 (1.28mm) swap to Red At layer #21 (1.76mm) swap to Orange for the rest.

Boost Me Got a Boost to spare? Every little bit helps the motivation. Thank you! Membership Want to go commercial or maybe just show some love? Consider signing up to show support!