Бесплатно 
Buckle Female Part
MakerWorld
3D-модель · MakerWorld
Buckle Replacement
Сведения о модели
- Площадка
MakerWorld
- Цена
- Бесплатно
- Лицензия
- PRIVATE-USE
- Только для личного использования: печатать для себя, без продажи и распространения.
- Форматы
- STL
- 151 Лайки
- 479 Загрузки
- 344 Напечатали
- 363 В подборках
- 10 Бусты
- 30 Комментарии
- 0 Просмотры
Описание
Boost Me If you are satisfied with the model and you could repair your backpack, please consider boosting this model, so that the model becomes more popular, so that others can repair their backpack too! Female Part: https://makerworld.com/en/models/617875#profileId-541565
One of my buckle on my Berghaus Munro Backpack broke.
A replacement was not available a long time, so i designed a similar buckle that would work with 1 inch straps.
Please print this Model at least in PETG, because PLA breaks very fast (I tried it).
For printer settings choose 0.20mm Strength, and Supports (Auto).
If it worked please consider leaving a comment.
Eine der Schnallen an meinem Berghaus Munro Rucksack ist kaputt gegangen.
Leider war das Ersatzteil nicht lieferbar, sodass ich eine Schnalle entworfen habe, die für 1 Zoll Bänder passend ist.
Das Druckmaterial sollte mindestens PETG sein, weil PLA sehr schnell bricht (ich habe es ausprobiert).
Für das Druckprofil funktioniert 0.20mm Strength und Supports (Auto) sollten eingeschaltet werden.
Wenn die Schnalle funktioniert, würde ich mich sehr über einen Kommentar freuen.
Руководства и профили печати
Профили печати и шаги
2 Buckles 0.2mm layer, 6 walls, 25% infill No Difference other than 2 Buckles
4 Buckles 0.2mm layer, 6 walls, 25% infill No changes other than 4 Buckles
1 Buckle 0.2mm layer, 6 walls, 25% infill - 0.2 mm layer height - print WITH support - infill does NOT need to be higher, only used in prong - just cheap PETG, but holds since one year
Double sided Buckle Connector - 0.2mm layer, 4 walls,25% inf It is for a rare use case when you need to connect two female buckles together.
Like for the old Decathlon ITIWIT dry bag, when you do not want to fully roll and close it.
Both PLA and PETG work well. Wait until it cools completely before using.
Let me know if you find any other uses!
Похожие модели
Названия используются только для указания источника результата. Polyzon не аффилирован с перечисленными площадками.