Goddess

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can change X and Y but Z must remain the same. You may print at higher layer heights below the Min Depth of 0.48mm Actual Depth is 4.5mm

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Jade White Transmission Distance: 5 PLA BambuLab Basic Silver Transmission Distance: 0.5 PLA BambuLab Basic Green Transmission Distance: 2 PLA BambuLab Basic Light Green Transmission Distance: 2 This print uses 6 unique filaments. Substitute as needed.

Swap Instructions: Start with Black At layer #12 (1.04mm) swap to Blue Gray At layer #20 (1.68mm) swap to Jade White At layer #31 (2.56mm) swap to Silver At layer #32 (2.64mm) swap to Black At layer #37 (3.04mm) swap to Green At layer #41 (3.36mm) swap to Light Green At layer #49 (4mm) swap to Jade White for the rest.

Boost Me Got a Boost to spare? Every little bit helps the motivation. Thank you!

Membership Want to go commercial or maybe just show some love? Consider signing up to show support!