Higher Z-axis dust cover Bambu Lab X1C P1S P1P

Membership If you want to use this model commercially, please join my membership. If you like my project, give me 👍, it will make it easier to reach others 🙂

Boost Me Each project takes hours or days of design and testing. There are also a few or a dozen test prints to make sure everything fits as best as possible. If you like my project, appreciate my work and want new projects of this type to be created in the future, support me so that I will be motivated to continue working 😉 Thank you for current and future boost 😉

Description:

I designed a dust cover that has about 1 mm of clearance above the z-axis screw.

In my case, the rubber cover of the screw on the right side sticks out more than on the left side.

This means that the available covers simply do not stay in place and fall off during printing.

There is no such problem with this cover.

The cover is available in two versions, one without the logo and the other with the Bambu Lab logo.

ATTENTION !!!!!

You should enable thin wall detection in the slicer.

Good luck and I invite you to test my other projects ;)

https://makerworld.com/en/@Piotrek.C