Cat Food Lid - Small cans

0.2mm layer, 2 walls, 15% infill, HF-TPU 95A, .8 retraction, under 100mm/s speed, 12 max volume flow This must be printed in TPU to easily flex over the can. I used the new BambuLabs HF-TPU 95A. There is no preset from Bambulabs for the HF version of the TPU yet so these are the slicer changes I made (they're probably not perfect):

- modify the filament settings changing max volumetric flow to 12 ( HF version only, regular TPU needs to be much less) - modify retraction length in “Setting Overrides” to .8 - change Speed settings to be under 100mm/s (change First layer infill, Outer wall, Inner wall, Sparse infill, Internal solid infill, Top surface, and Gap infill all to 100mm/s (again regular TPU will be much slower) - In others tab change print sequence to “By object” if printing more than one at a time - also, make sure filament is dry! These settings worked pretty well leaving only a small amount of stringing.

TPU for AMS - 0.2mm layer, 2 walls, 15% infill Just a print profile for TPU for AMS filament.  Works great.