A1 Poop Bucket with scraper holder

With scraper holder 0.2mm layer, 2 walls, 15% infill

Without Scraper Holder 0.2mm layer, 2 walls, 15% infill

PLA_Speed_optimized with Scraper holder - 2h7min I’ve optimized the settings for the perfect balance of fast printing , low material usage , and high strength

Shorty: light weight, less filament, faster Shorty version using less filament prints faster and light weight.

Must use a poop deflector.

*Bin without high left Wall* 0.2mm layer, 2 walls,10% infill Alternative geometry of the pop bin without the left wall to use an external deflector . And save time (almost an hour with the same Quality)!

Shown in the picture with the deflector from dkduck.

( https://makerworld.com/de/models/154673?from=search#profileId-423074)

Shorter in length, less filament 64g, less time 2h23m Shorter in length, because of this is using less filament and it prints faster and light weight.

Must use a poop deflector since this does not have the high left wall

impression plus rapide et économique couche de 0,20mm

densité de remplissage 5%

motif de remplissage gyroide

PETG_Speed_optimized with Scraper holder 🚀 PETG  Speed Optimized

A speed-optimized PETG  profile focused on fast printing while maintaining a good balance between print quality, strength and reliability.

🔗 Also available PLA Speed Optimized !

You can find it on my profile or in the Print Profiles section of this model.

If you find the profile useful, a Like 👍 is appreciated!