D20 Ice Cube Holder (42mm ice cube, can be resized)

I've been working on this for a while now.

This is version 4. I did a test print of version 3 (the files you see) and just needed to add one small thing to it to get the connection between the halves ready, so I did that, and I'll do another print again soon. I scaled it to 75% to save some time and filament.

Anycubic Kobra 2 Neo.

Default Lychee settings for filament.

Print in place. Print on plate.

If you're going to make one of these and use it, you need food safe PLA. There is some out there! It's a bit pricy, but definitely safer. I used colour changing green filament, it goes yellow over 31 degrees C (in light, to touch, heat in its direction) and then back to green as it cools. It was a test, I'm not selling it or making ice out of it (that you know of) so it's fine. :)