NOIR Webcam Case for RaspberryPi Zero

This is a Case designed for a raspberry pi Zero, an NOIR camera module from Piomoroni and a 40mm 5V Fan.

For assembly you need:

4 screws M2,5 x 8 for the front plate assembly

4 screws M3 x 15 for the fan assembly

4 screws M2 x 12 for the camera assembly

The IR-LED are fixated with hot-glue or super-glue

The used PI Camera Module:

https://shop.pimoroni.de/products/night-vision-camera-module-for-raspberry-pi

The 40mm 5V fan is recommended since the IR LED produces a lot of heat when running permanently. It also allows to overclock the pi-zero board without thermal problems. Heat sinks for the IR-LED and the PI ZERO cpu is recommended.

My camera is running the "motioneyeos" linux distribution as a operating system.

https://github.com/ccrisan/motioneyeos/wiki

Additionaly I have added a simple reed-Relais to a GPIO pin to switch the IR-LED on and off via the web-browser using action-buttons

https://github.com/ccrisan/motioneyeos/wiki/Action-Buttons

Print instructions

Category: Electronics Print Settings

Printer Brand: Original Prusa

Printer: i3MK3

Rafts: No

Supports: No

Resolution: 0,2

Infill: 15%

Filament: PLA Green