V0.2 (R1) Light EBB36 Mount & Strain Relief

V0.2 (R1) Light EBB36 Mount & Strain Relief

This light weight mount comes in at a smidge over 5g of plastic. it also lowers the Board slightly for better centre of gravity.

the Mount itself features rails to allow for wires to be tied or fed though helping to keep some of the spaghetti under control. there are 2 versions

V1 has short rails down each side

V2 has extended rails down each side and at the bottom corners

the mount has mounting points for both the standoff's and to the rail mounting to keep things nice and secure.

the strain relief has 2 versions to choose from so you can select the one that works best for your setup. one has a 10 degree tilt back while the other has a 15 degree tilt. they also feature my “no loss of cable tie” system the strain relief is screwed onto the mount so when you need to remove the umbilical cable just unscrew it and it stays with the cable!

both V1 and V2 have both strain relief parts pre-laid on a V0 bed so just slice and print the one you want!

BOM

7 off M3x8 BHCS

3 off M3 inserts

as always please follow the voron design print settings

5 top / bottom layer

4 perimeters

40% infill

ABS / ASA are best for these parts

happy printing!