Elite NOVO FORCE Adapter - Quick Release to Thru Axle Conversion (12mm)

This 3D printable adapter allows you to use your Elite NOVO FORCE trainer with bikes that have 12mm thru-axles, even if your trainer only supports quick-release skewers. The adapter has been specifically designed and tested with the Canyon Endurance 6 AL bicycle.

Key Features:

- Simple slip-on design that fits over the existing quick-release mechanism - 12mm thru-axle compatibility - Easy to install with no modifications to the trainer required - Made for Elite NOVO FORCE trainers Printing Instructions:

- Recommended material: PETG - Layer height: 0.28mm - Wall perimeters: 3 - Infill pattern: Gyroid - Infill density: 15% (sufficient due to metal rod reinforcement through the center) - Print with standard settings for structural parts Post-Processing Steps:

- Lightly sand the surface for a smooth finish - Clean thoroughly to remove any debris - Apply a thin layer of petroleum jelly before use for optimal performance Installation: Simply slide the adapter onto the quick-release mounting rod of your trainer. The rest of the setup remains unchanged from the standard procedure.

Note: This is a community-created adapter designed to enhance the compatibility of the Elite NOVO FORCE trainer. Always ensure proper installation and regular inspection of the adapter during use.

Disclaimer: Use this 3D model at your own risk. The creator assumes no responsibility for any damage to property or equipment that may occur while using this adapter. By downloading and using this model, you acknowledge and accept full responsibility for any consequences of its use.