Shallow Water Rc Jet Boat

Parts (what I used)

Bronze Bushings -

https://www.amazon.com/gp/product/B07JLPC8TS/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

Shaft Couplers -

https://www.amazon.com/gp/product/B0867P8H6D/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

Servo -

https://www.amazon.com/gp/product/B0BLBMVYCW/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

Esc -

https://www.amazon.com/gp/product/B071GRSFBD/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

Motor -

https://www.amazon.com/gp/product/B08DLT47JS/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

Receiver -

https://www.amazon.com/gp/product/B09MVY4W7G/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

Driveshaft -

https://www.amazon.com/gp/product/B083NXGP98/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

Uses a 3s battery

Hull is printed as vertical as possible on the Bambu Lab x1c with 1 parameter for weight

Seal is printed out of ninja tek tpu

Lid is attached by 7 4-40 screws and nuts

Servo mount is held on with double sided tape

Esc is encased in resin in case of water entry

Receiver is coated in clear nail polish (I don't know if this actually works but it is still alive)

Fairly waterproof but not perfect (servo hole gets drilled by hand)

Will stall randomly if too much current is drawn