Belt Printer Pressure Advance Test Tower

Simple PA test tower for belt printers. It should work for IR3 and CR30.

Print in vase mode, one shell, zero top and bottom. In your slicer, enable a PAUSE at about 23mm high. Then, start your PA test after that point.

Here is some great information about the tower.

https://ellis3dp.com/Print-Tuning-Guide/articles/pressure_linear_advance/tower_method.html

After the print has *already started**, enter the following command:

- (Direct Drive) TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.0025 - (Bowden) TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.025