Extension Lever & Voron Stealthburner extruder body for Bondtech LGX Lite & Lite v2 - Part I

I upgraded my Voron 2.4r2 FDM printers to Stealthburner from the original Afterburner and after testing I replaced the original Bondtech LGX extruder to the smaller and lighter LGX Lite v2 which utilizes the large filament gears as the original did.

Using the original Voron Stealthburner CAD drawings of CW2, I modified them to fit the LGX Lite.

The only short come of the LGX Lite v2 is the filament lever is too small to operate when mounted inside the Stealthburner. Therefore, the creation of this lever extension.

I have also uploaded Rear Cover for Voron Stealthburner extruder for Bondtech LGX Lite & Lite v2 -Part II

Parts Used

- Extruder Bondtech LGX Lite V2 - ECAS04 - M3 Threaded Inserts VORON - Filament used: Polymaker ASA Filament 1.75mm Blue NOTES

- The lever is directional, and the tab should face forward. - The lever should be installed on the LGX extruder before bolted on the extruder body. - This extruder body should fit with any other hot mounts, but is only fully tested with the Mosquito variant.