TRX4m Bronco rear gas can holder

This is a jerrycan holder I made for the TRX4m Bronco. It can hold either the stock jerrycans from the Defender or my design, which can be found here: https://www.thingiverse.com/thing:6871004

It utilizes the stock hardware, and fits under the stock spare holder. It should be spaced just right to have a normal sized real spare mounted (~53mm diameter). Print facing up, as it is in the STL. You will need supports for the stalk - I recommend tree supports to have it easily removable.

I am still working on ways to secure the jerrycans onto the holder. For the time being, I will be using a rubber band. Not the most official way, but very effective.

If you print this, please post a make! It helps me gauge community engagement and know what I need to do better. Your feedback is incredibly helpful to me!

Print Settings

Rafts:

No

Supports: Yes

**Resolution:**

I would advise fine resolution to preserve some of the small details.

Infill: 30%

Notes:

I just printed this at 30% infill, and it seems sturdy enough. I was worried about the thinness lending to structural instability, but that is fortunately not the case here.

Category: R/C Vehicles