200mm Desk Fan Stand (noctua 200mm NF-A20)

Model Name: 200mm (Noctua) and 120mm Fan Stand using rubber mounts – 25° Angle (Mini Build Plate Friendly)

Summary: A compact fan stand designed for 200mm Noctua fans, angled at 25°, and sized to fit within the 170mm build volume of a Mini Bambu Lab printer. It can also hold 120mm fans using rubber mounts (not screws).

Description: I designed this fan stand to hold a 200mm Noctua fan at a 25° angle. The model is compact enough to fit on a Mini Bambu Lab printer (under 170mm in size).

It can also support 120mm fans, but note that these must be attached using rubber mounts or zip ties — standard screws won’t fit in this case.

Power Setup: I use a USB to 4-pin fan converter with fan speed control (found on AliExpress , link not affiliated).

Noise reduction tip: I suggest using rubber feet to minimize vibration and noise I used 1.5 cm feet, but any similar size should work

Print Settings:

- Infill: 15% (works well, no need to go higher)

- Material: PLA

- Nozzle 0.4mm