EEW 6 Sectional Bobbin

You should print 6 of the disks, 3 of the tubes, and 4 of the plugs. Then assemble them onto an EEW 6.x bobbin. The plugs get inserted to hold these from spinning on the bobbin. Then you can spin small amounts of different singles onto a single bobbin.

This video shows how to assemble. If the plugs don't prevent all the rotations you can alternately just use a little tape to make sure those sections can spin.

If you want someone else to print these files for you, there is more information about that on this page: https://www.dreamingrobots.com/eew-3d-printed-parts/

For more information about the EEW 6.1 eSpinner visit this site: https://www.dreamingrobots.com/