Sovol SV08 Top Hat Side Exhaust Single Layer

I plan to get proper images up after I get mine printed.

For the single layer version the BOM should match the OG version of the side exhaust.

BOM

Heat set insets

M3x3mm long 11 pcs. to secure the top panel to the top hat

M3x4mm long 2 pcs to mount the exhaust filter to the top hat

Screws HSCB

12x M3x35mm to secure the top hat in to the frame

2x M3x22mm to secure the exhaust filter to the top hat

11x M3x6mm Flange heat screw to secure the acrylic top panel in to the top hat

The Exhaust also by Nadir can be found here → Sovol SV08 Exhaust Filter by Nadir

The warnings remain the same.

WARNING: Calibrate shrinkage before you print. These are long pieces and errors will show.

Suggested Filament choices for this project - ABA, ASA, Polymaker HT-PLA, and PETG

Suggested Print Setting

3 Walls 5 Top 5 Bottom 15% Infill Gyroid