20mm Webbing/Strap Keeper (STEP & STL)

This is a keeper for loose ends of webbing on a backpack so they're not flopping around. This is made for (2) pieces of 20mm webbing. If it's tight, you can scale it's width in the X axis in your slicer. This is firm on an Osprey pack I have while it's a little looser on a Cotopaxi. Webbing thickness can vary.

Print as oriented in PETG. PLA will open/creep over time.

This is meant to slide with a little resistance and not load bearing vs something like a tri-bar buckle which locks straps in place and is load bearing. Overlapping tabs on the opening help keep webbing in the keeper.

STEP included to edit as desired for other sizes. You might be able to scale as needed in a slicer.

Feed the webbing in to the keeper, one at a time at an angle.