Horns on hairband v2

The horns have a tight fit on the hairband so that you can adjust the position as you like, no glue needed.

Horns printed in PLA (matt PLA was used for the pictures)

- both 0.1 or 0.2 mm layer height should work. - 15% infill is sufficient for having good stability at the base (you can add a modifier with 0% infill at 60mm height) - for best quality print horn separately Hairband PLA or PETG

- both 0.1 or 0.2 mm layer height should work. - no infill needed - organic support for the connectors Hairband adjustments:

- too narrow … try to gently bend it in your hands - too long … cut the ends with a cutter knife or side cutter and sand the sharp corners