Ender 3 v3 SE nozzle wipe brush

G-Code I use (use at your own risk):

M220 S100 ;Reset Feedrate M221 S100 ;Reset Flowrate M140 S[bed_temperature_initial_layer_single] ;Set final bed temp G28 ;Home G92 E0 ;Reset Extruder G1 Z2.0 F3000 ;Move Z Axis up M104 S[nozzle_temperature_initial_layer] ;Set final nozzle temp G1 X1 Y-18 Z3 F5000.0 ;Line up with brush M190 S[bed_temperature_initial_layer_single] ;Wait for bed temp to stabilize M109 S[nozzle_temperature_initial_layer] ;Wait for nozzle temp to stabilize G1 X87 Y-16 Z.6 F5000.0 ;Wipe 1 G1 X124 Y-16 Z.6 F5000.0 ;Wipe 2 G1 X87 Y-16 Z.6 F5000.0 ;Wipe 3 G1 X124 Y-16 Z.6 F5000.0 ;Wipe 4 G1 X87 Y-14.5 Z.3 F5000.0 ;Wipe 5 G1 X124 Y-14.5 Z.3 F5000.0 ;Wipe 6 G1 X87 Y-13 Z.3 F5000.0 ;Wipe 7 G1 X124 Y-13 Z.3 F5000.0 ;Wipe 8 G1 X40 Y-18 Z15 F5000.0 ;Raise to clear brush G1 X-2.0 Y20 Z0.28 F5000.0 ;Move to start position G1 X-2.0 Y145.0 Z0.28 F1500.0 E15 ;Draw the first line G1 X-1.7 Y145.0 Z0.28 F5000.0 ;Move to side a little G1 X-1.7 Y20 Z0.28 F1500.0 E30 ;Draw the second line G92 E0 ;Reset Extruder G1 E-1.0000 F1800 ;Retract a bit G1 Z2.0 F3000 ;Move Z Axis up G1 E0.0000 F1800