Floppy Gingerbread Couple!

It's a floppy gingerbread couple!

This model does require multi-color capabilities.

When importing the model into your slicer, make sure you select all parts before clicking on “Open”

If done right you should get the following dialog:

Select “Yes” so everything gets oriented properly together.

You can then use the slicer to paint each part.

Printing Instructions:

The 3mf files provided were created using PrusaSlicer and should already have the following settings configured.

- Layer height: 0.2mm

- Wall loops: 3

- Supports: None

Make sure you have your build plate nice and clean to avoid adhesion issues. Either clean it with an ammonia based cleaner like Windex or clean it with high quality dish soap and warm water. IPA also helps, but not guaranteed to work.

Thank you for your time and consideration on this matter.

For those who have joined my club at the “Obsessor” tier or have subscribed to my commercial membership on Patreon , prints of this model can be used for commercial purposes.

Feel free to join my discord for additional support, questions, or suggestions!