Headphone Stand

I wanted a headphone stand that was tall enough to hold my Hifiman i400, so I made this in Fusion 360. I split it in half so a Prusa Mini can print it as well :)

It needs small support when printing the upper arm part as well as the base, and a brim around the lower arm.

Print Settings on MK3S:

I used the 0.3mm Draft preset.

Base:

- 0.3mm - 15~20% Infill - Any infill pattern - I use gyroid @ 15% - Add support in the opening Upper arm:

- Same as above - Print it laying flat - Support underneath the connector Lower Arm:

- Same as above - Print it standing up - Add a 5mm brim to prevent lifting from the build plate Assembly:

- A small amount of superglue when you join the parts together.