Razer Barracuda X and Xbox Controller Combo stand

Credit to

and

for their models used in this model's creation.

OTHER HARDWARE NEEDED:

1x M3 (10mm) screw and a small pilot hole made by a drill using the speed mode for attaching the headphone holder.

Super Glue for connecting all the parts together, and when doing so, let it sit for a few minutes with around 10 lbs. of weight pushing it down.

Sandpaper ~220 grit for sanding of support interfaces on Headphone holder or anywhere else issues are caused

Print Settings:

For supports, use tree, as other styles use un-necessary filament.

For infill, use gyroid with 10% infill

Notes:

If needed, change the size of the joint module if your printer needs a slightly different size in order for the model to work.