BTT Manta M5P Stepper Fan Mount

This design is inspired by

I completely remade this, because I wanted better printability with less bridging and a different fan mount direction. One of the fans is flipped, so that hot air from above the MCU is expelled. I also wanted to use standoffs, because they can stay screwed in and hold the Manta in place when you take the fan mount off.

BOM:

- 3x M3x15 standoffs

- 3x M3x6 or M3x8 screws

- 2x 4010 fans (I use GDSTIME 4010 24V dual ball bearing)

- 8x M2.5x6 screws for the fans, they thread into plastic