Shower door gasket

A simple gasket to reduce leaking along the edge of a glass shower door. Made in sections, 250mm long, to fit the bed of the printer. I needed nine and a bit sections for my stupidly high door.

Printed in Elegoo TPU 95A, though any similar flexible filament would do OK. It helps to set up so that the seam and any stringing is at one end of the part, it can easily be cut with scissors to remove the seam, stringing, and to make it fit.

Its sized to fit my 10mm thick glass shower door. It can easily be scaled in the slicer, to suit different thickness doors.

Attached with a waterproof (I hope) silicone sealant, cheap stuff from the supermarket. Just a dab at the ends of each section should be enough.