Deck to garden light housing

Deck Light to Garden Light Conversion Housing

I had a set of old lights from a deck I tore down and wanted to convert them into garden lights. Modelled a housing to hold the fixture and a post to embed in the ground. The angle of the light can be adjusted and tightened by a screw.

The main body of the fixtures is approximately 25 mm.

Print Settings

Printer Brand:

Monoprice

Printer: Maker Select

Rafts:

No

Supports: No

Resolution:

0.3

Infill: 50

Filament: iPrint-3D PETG Black

Notes:

Print the housing pointing up to avoid needing any supports. The post prints flat on the bed.

Category: Decor