Voron V2.4 Flex Plate Holder

Spring steel flex plate holder which attaches to the top extrusions on a V2 (I think this should also fit a V1/Trident as well) and holds up to 3 plates. 250mm, 300mm, and 350mm total lengths available. I have 3.4mm thick panels and 1/8 inch thick foam on my printer which these are designed for. You may need to use the STEP file to adjust that if your panels and foam are significantly thicker, if thinner then tape of foam can be used to pad the difference.

3D PRINTING SETTINGS

Printed at 20% infill with 3 walls in ABS. You will need two M3 roll in or hammerhead t-nuts and two M3 x 10-12mm bolts. Print with logo face down and at a diagonal across print bed to fit. You may want to use a piece of VHB tape or foam at the bottom if the bracket doesn't sit flush on the panels to prevent rattling.