Bike wallmount with wood inserts (horizontal storage)

This bike wallmount is inspired by some that I've seen online, it's a simple bracket that gets screwed to the wall, then you can insert a wooden peg (30mm diameter) into it on which the bike rests.

Instructions:

- Print two brackets without supports with the surface facing the wall towards the heatplate. I recommend printing with 80%+ infill so it's solid and chunky (I used PLA).

- Get plugs, screws and a fitting 30mm wooden peg from your local hardware store.

- Install & admire your work.

Depending on your wall material, plugs and screws I estimate it can take a bike weighing up to 15-20kg - good plugs are essential. You could of course scale it up for bigger screws/plugs/pegs and it should be able to take more weight.