The Goose Spinner of Gloom

THE GOOSE SPINNER OF GLOOM

This is a goose with a lust for destruction. (Occasionally). His deep, blank eyes stare into the eyes of the enemy as he charges. Don't let his albeit derpy face fool you. He has a hunger for danger. (Usually).

This model is perfect for anyone who is looking to print a spinning top for battle or for goose lovers alike. This model is perfect for battling with friends or just as a gag gift. And you know what is better than one spinning goose? An army of them...

Steps for Easy Assembly (as shown below):

- Push the point of the spinner into the base until a click.

- Place the peg cylinder-side-up into the flat side of the base.

- Slot the blade into the peg. Make sure the flatter side of the blade is on the bottom.

- Slot the top of the spinner onto the peg. Make sure the face is in the opposite direction of the goose's tail on the blade!

- Wreak havoc on other spinning tops by battling them!

To Put the Ripcord and Launcher Together:

- Slot the head of the goose spinner into the bottom hole of the launcher.

- Slide the ripcord into the side of the launcher, making sure the teeth of the ripcord are facing towards the goose spinner. (Remember to put the ripcord into the correct side of the launcher. If unsure look at the photo at the very top with the ripcord and launcher included).

- Slide the ripcord in all the way. The goose spinner should spin while this happens.

Supports shouldn't be needed for any of the parts except for possibly the center peg. PLA can be used but PETG is recommended for better durability especially when battling other spinners. 100% infill is recommended for the base and blade. This will make sure the center of gravity is near the base for better stamina when battling. The goose face colours can be painted on after 3D printing or painted on in the printing software used.

Glue is not necessary for this model, however it can be used to provide extra strength to the joints.

Disclaimer:

Due to a lack of a 3D printer, personal testing of this model hasn't been possible. However research was done on dimensions and careful work has been done on the measurements of the model to help ensure the functioning of this model. If any issues arise with the measurements of this model, I will be happy to rectify these issues where possible.

Likes, makes, downloads and comments are all greatly appreciated.