Inmotion V9 Kickstand

This is a stand / kickstand for the Inmotion V9 Electric Unicycle [EUC]. I took a scan of the original kickstand using photogrammetry, cleaned it up a little, and made some cuts to make it look a little better that are inspired from another design. Can be installed on front or rear.

Print settings

- Minimum 4 walls (0.4mm nozzle, so 1.6mm of walls)

- Minimum 20% infill

- 5 bottom and top layers

- [Recommended] Enable Alternate Extra Wall (Orcaslicer) for infill to better connect to outer walls.

Recommended filaments

HT-PLA, HT-PLA-GF, PC, PC-CF, PC-GF, PCTG, PET-CF, PET-GF, Any filled Nylons (PA-6, PA12, glass, nylon), ABS, ABS-CF, ABS-GF, ASA, ASA-GF, ASA-CF.

Please note that PETG isn't on here because it's not a good filament for nearly any real-world use case. Use at your own risk.