Party glasses 1985

I simply changed the numbers from 2026 to 1985. The design remains similar, while the hinges, the left and right arms, and the mounting system are identical to the original. These glasses are a remix of a model created by rorys3d. That is why I am pasting the description provided by the original creator below:

Printing:

Print takes about 1h12min on CORE One and I recommend to use color-change during print, e.g. first 7 layers with one color and rest with black color. But of course you can go without color-change as well.

- Use PLA to bend the front part well in hot water.

- Use brim for the temples.

- Custom supports are ready for the revolute joint of the temples and work well for 0,2mm layerheight .

Post processing:

- Remove temple brims and clean the edges.

- Bend the front frame a bit using hot water (or heat gun) and coffee saucer. Hot tap water was sufficient in my case.

- Remove small support block from the temples (inside joint).

- Try to insert piece of filament into the holes. The holes may probably need to be enlarged.

- Slide the temples onto the frame and insert the filament.

- Trim the end of the filament.

- Enjoy the party ;)