Generic squash ball feet

I quickly modified a couple of popular models of squash ball feet because i found out that if you move the printer without lifting it enough, the grip it makes onto the surface might break them off, especially if you glue them without screwing on the chassis (like i did). So i increased the surface they make contact through, so that it reduces the lever in the case it grabs too hard when you move the printer. I advise both a little bit of glue and a screw.

Print Settings

Printer:

Artillery 3D Sidewinder X1

Supports:

No

Resolution:

0.3 mm

Infill:

20% cubic

Filament:

eSun PETG

Notes:

Printed with hollow hemisphere side up