Airsoft AEP Tappet Plate for MP7, VZ61, and MAC10 remix only print petg or nylon

if anyone need a tappet plate to mp7, mac10, skorpion aep i made a remix on a model in thingiverse that works fine now tested now 3 mags i printed in petg but i recommend to use nylon and two little metal nails

(the arrows on first picture show the correct area to put the pins)

(to put in tappet you need to heat the nail) the heat nail prevent the tappet 3d print to delaminate

mp7 with little tab print in this orientation and glue the the tab at correct angle

print with 100% infil only petg or nylon (abs is not strong )

Print Settings

Printer:

EZT t1

Rafts: No

Supports:

No

Infill: 100%

Filament: generic petg or nylon only

Category: DIY