4040 Power Switch Housing (Ender 3 V2)

I was using a different file for some time but it got a bit loose and I wasn't comfortable having 240V connected to a loose fitting with kids around. The resulting part is nice and tight fitting and locked down with the built in M3 nut cut outs. Please note the first time you install this it might be a very tight fit but with some gentle convincing (tapping from the front) it should slide in. Mine did anyways.

Use M3 10mm screws (and nuts) to fix this in place.

Prints fine with no supports. I personally printed it at 0.2mm layer height and 15% infill.

* This is for use on the right hand side of the printer (looking at the front). If you want the switch on the left hand side, mirror the part to suit. *

Finally, please be careful messing with mains power!

Category: 3D Printer Accessories