Caddx & DJI Air Unit Camera Seal/Sleeve/Boot for FPV

If you replace the camera cable on a DJI Air Unit you will eventually lose at least one of the seals because you have to cut it to remove the cable from the back plate of the camera. This also applys to the caddx vista when you use it with the DJI camera. Therefore I made this seal. From scratch. ;-)

You have two options:

- Use the seal without the incision. You need a sharp tool, e.g. a cutter, to cut it so you can wrap it around the cable. - Use the seal with the incision. This requires a very precise printer. ⇒ I would go for option 1.

Filament: Sainsmart TPU emerald

Notes:

You have to enable "supports everywhere". If your printer is set up well, the removal shouldn't be big of a deal. Print as oriented.

Category: R/C Vehicles