Sith Holocron Display Stand

I liked @DarthExtruder's original stand for the Sith Holocron from Galaxy's Edge, but it was a little too tall for my display area. I liked the design of the base, so I cut it down, enlarged it to fit under the entire holocron, angled it a little and placed the Sith Empire symbol into it.

There are two versions, one with the symbol inset into the display and one with it raised a little. This is my first remix and serious mod of any design and I am sure there are issues, but it printed fine for me. :-)

Printing:

It is simple and straight forward. I used 20% infill, and .16 layer height, but it should print fine at .20 layers and any infill you choose.

Print Settings

Printer Brand:

Creality

Printer: Ender 3 Pro

Rafts:

No

Supports: No

Resolution:

0.16

Infill: 10% - 20%

Filament: HatchBox PLA Any

Notes:

I used a resolution of 0.16 to get better detail on the symbol embedded in the display stand, but any resolution should work. It is not supporting a lot of weight so use whatever infill works for you.

Category: Other