Steam Coaster

Available pre-sliced with the settings listed below, or as a .stl.

Print Settings:

- Color change : PrusaSlicer will most likely detect this file as a logo, and suggest a color change automatically. If it does not, or you are using another slicer, add a color change at 3.2mm (assuming a layer height of .2mm). - Ironing : While not necessary, ironing makes this print look much better. For PrusaSlicer, I used “All top surfaces”. Right click part in PrusaSlicer → Add settings → Ironing → Check Enable ironing and Ironing Type → select Ironing in the right window → check Enable ironing, and set type to All Top Surfaces. - Infill : I used 50% to make it a little heavier, but anything should work. - Layer Hight : .2mm, I assume a lower height would work fine, but there would be little benefit. Be sure to calibrate your color change layer if you change the layer height. - Nozzle : I used a .4mm nozzle, smaller should work. Larger than .4mm will probably lose some detail.