Celtic Knot Bobbin disks for the EEW6

These are Celtic knot bobbin ends for the 3d printer friendly bobbin designed by Maurice for the EEW 6.

These are the same designs as on my nano bobbins, but sized up and put on the bobbin ends for the EEW6 from Maurice's printable bobbin.

There are two designs: raised, which is a knot design on a series of foundation rings for strength, and cutout, which is the same knot cut out of a disc. You don't have to use the same design on both ends of one bobbin, or you can make them match.

For one bobbin you will need to print:

- one bobbin disk 1a - one bobbin disk 2 - one bobbin disc 1b found here https://www.printables.com/model/219433-eew-60-bobbin-3d-print-friendly/files - one bobbin tube found here https://www.printables.com/model/219433-eew-60-bobbin-3d-print-friendly/files Please see the instructions and the source and specifications of additional bearings Maurice calls for on the original bobbin, these are ONLY THE DECORATED ENDS and must be used with his 4-part printable bobbin, not the injection molded OEM bobbins. https://www.printables.com/model/219433-eew-60-bobbin-3d-print-friendly

I do not have a EEW6 so I have not printed a test version. Test print shown was printed by B. Cook.