Castle Towers Planter

Castle towers for your succulent? Yes, another succulent planter for your desk or home. The retaining wall acts as a mote and drain for over watering. Plenty of ventilation for the roots and bottom. The mote can be used to bottom feed by adding water to the mote or courtyard.

This was printed using BamTack PLA at a resolution of 0.2 and 20% infill. There is no need to use supports when printing. All the over hangs are arched and should print just fine without support.

BAMTack PLA: https://amzn.to/2vXR58E

My Printer: http://amzn.to/2BBYP4t

If you like this thing, then check out my other things: https://www.thingiverse.com/Qrome/designs

Print instructions

Category: Containers Print Settings

Printer Brand: Monoprice

Printer: Maker Select

Rafts: No

Supports: No

Resolution: 0.2

Infill: 20%