Crankbait Fishing Lure

This is just another Crankbait I made.. this one a redesign of a lure I carved out of balsa wood 25 years ago.

I'm still working out the best infill settings so this is a* "Work in Progress" * for now.

I did a short write up on my website TheNeverEndingProjectsList for this lure so if you would like more info click the link.

For now there are two versions...

* Crank_Bait_w-Lip.STL * has an attached lip. (this is the one shown) * Crankbait_No_Lip.STL * has a separate lip that can either be printed and used as a template to cut a clear lip or it can be printed and glued on. (I'm not sure how hard it will be to attach the wire for the tie on points though.

* CrankBait_Stripes_Stencil.STL * is the stencil I used for the strips. * Crankbait Stencil Blank.STEP * is a blank version you can edit with any pattern you like.

Enjoy.... and post some makes if you use these it lets me know I'm not wasting my time uploading my designs and if you like what you see check out more of my lures at https://www.theneverendingprojectslist.com/

Print Settings

Rafts:

No

Supports: No

Resolution:

.10

Infill: ?

Notes:

I only use supports on the stencil.

I'm still figuring out the best infill to use.

Category: Sport & Outdoors