DREMEL drill press

This model is a REMIX of 3Deddy's model from Thingiverse: https://www.thingiverse.com/thing:4148260

It's modified to fit the Prusa MK3S+ printer and it has several improvements :

- Smaller base, so it can fit to the printer bed

- Divided plate on the base, so you can print it directly on the bed and it will have a nice flat surface

- Divided Dremel 4000 holder, so it can fit to the printer

- Cap for the pipe

- Modified kable guide

Print settings

- PETG

- 0,2 mm

- 15% infill

- Supports are needed for most parts

BOM:

- Aluminum (or steel) pipe - 22 x 2 mm (cut 2 pieces: 350 mm and 250 mm)

- 625ZZ bearings - 5 x 16 x 5 mm (6x)

- M5 Nuts (13x)

- M5 Washers (11x)

- Hex head screws:

- M5 x 45 (1x)

- M5 x 30 (6x)

- Socket hex head screws:

- M5 x 30 (3x)

- M5 x 20 (4x)

- M5 x 15 (1x)

- Flat hex socket head screws:

- M5 x 20 (4x)

- M2 x 6 (1)

You can buy the parts from Accu Components: BOM

Assembly:

- Mount plate to the base by 4 flat hex socket screws:

- Mount 350 mm pipe to the base by M5 x 30 screws (3x), M5 nuts (3x) and washers (6x):

- Assemble bearings and vertical guide by socket hex head screws M5 x 20 (4x), M5 x 30 (2x) and 6 nuts:

- Mount 250 mm pipe to the Dremel holder by M5 x 30 screws (2x), M5 nuts (2x) and washers (4x):

- Mount the top cap to the Dremel holder and 250 mm pipe by M5 x 30 socket hex head screw, then mount the cable guide by M2 screw:

- Put a vertical guide to the pipe of the Dremel holder:

- Assemble the vertical guide to the 350 mm pipe on the base by vertical guide lock knob, M5 x 45 screw, and nut. Then add a cap to the top of the pipe:

- Glue together the lever and prepare the lock knob for the lever, M5 x 30 hex head screw, washer, and nut:

- Assemble the lever (M5 x 15 screw):

- Mount the DREMEL: