Vase 715

A wavy pencil/pen vase for decorative purposes to hold pens and pencils, or anything else.

It is 111mm tall and 80mm wide.

Print time approximately 1 hour and 50 minutes with a single wall at print speed of 50mm/s.

The photo shows the vase printed in vase mode. It can be printed in normal mode with 0 top layers and 0% infill . The stl file is solid. It prints great in either vase mode or normal.

The photo shows the vase printed in copper by Tecbear.

Print instructions

Nozzle size: 0.4 mm 0.2mm layer height 0.8mm wall line width recommended 50mm/sec print speed Spiral Vase Mode enabled (spiralize outer contours in Cura)