Kywoo 3D Tools - Filament holder

I created this filament holder for my Tycoon Max.

Initially, the PTFE tube goes through the opening a little tightly, but over time the PTFE will then be easier to pass through. I purposely designed it so that after some time, the PTFE would not be pulled along by the feeder during printing. I've printed with it for almost 100 hours, and it's still working with no problems.

I'm always open to comments for improvement!

Print Settings

Printer:

Kywoo3d Tycoon Max

Rafts: Doesn't Matter

Supports:

Yes

Resolution: 0.2

Infill:

0.15

Filament:

TINMORRY PETG Black&White

Notes:

The filament holder fits on every printer. I printed out Part 2 individually in white and glued it to the filament holder. I used M3x8 screws.

Category: 3D Printer Accessories